Active RS 701-2, wired

 

This machine has been designed to work in very difficult conditions. Its major advantage is the strength, which is the result of the application of the housing made of high grade stainless steel. On both sides of the device in the upper part, there are holes with 3 LEDs on the page. LEDs produce very intense light visible even from a distance of more than 800 m. To power the equipment needed is AC 110 or 220V or DC 12 or 24 v. Rugged and very bright light, which can have several colours, make this device ideal for bend lighting. The ability to integrate with the combat system-Safe ™

· Active
· Reflection: 450 mcd/lux-500 mcd/lux
· Dimensions: 160 x 60 mm
· Weight: 2.5 kg
· Certificate of conformity with EN 1463-1:2009
· Colors: colors

  • Significant improvement in road safety through effective lighting at night and during inclement weather.
  • Very easy and cheap installation of the devices.
  • The brightest LEDs on the market.
  • Brightness control, the intensity of the light and different effects with the driver.
  • Zero maintenance costs, equipment once installed do not require any maintenance.
  • In the event of a fault, the ability to repair without removing the device from the ground.
  • The ability to replace the standard lighting of roads, which is expensive to install, but also and.
  • The devices are very energy-efficient, and completely safe for the environment39a3319569558a87b9fd6709dfc8725c

Model

active, wired

Reflex

Dimensions:

Ø160 mm x 60 mm

The weight of the

2.5 kg

Casing

Stainless steel 304, aluminium

Load carrying capacity

30 ton

LED Quantity

2 or 3 on the page as it is in the description of the

The visibility of the

800 m

Temperature range

-40 to 75 ° c

The tightness of the

IP 68

The certificate

· Certificate of conformity with EN 1463-1:2009

colors

 colors

Assembly instructions point reflectors type RS-710-2
1. You must properly mark and clear the place of installation and make sure that the surface is dry.
2. Using the drill/drill, drill a hole of the desired width and depth.
3. Dimensions:
-RS 710-2: bore diameter 160 mm, width 65 mm
3. Remove leftover asphalt from the hole, preferably by strong blowing air from the blower and make sure that the bottom of the hole is dry.
4. Pour the epoxy adhesive or b into the hole and prepare the desired element.
It is allowed to use glue: epoxy resin and hardener.
On average one holes need about 35 g. The glue should fill in the hole. The whole package should be placed in the ground and filled with adhesive.
5. Set the device in the right direction and then put in the hole.
6. The upper surface of the device should be on an equal level with the road.
7. Remove adhesive residue.
9. Again to verify that the device is set in the desired direction.
POBIERZ PDF